|
|
The Newbies Arena Are you new to knife making? Here is all the help you will need. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Drill Press RPM's
So I'm just about ready to start drilling some pin holes in my first know and I'm wondering what drill speed I need to use? The chart I'm looking at says 3000 RPM's but that seems a little high. I'm using a 1/8" bit to go through 1/8" thick 1095. What speed should I use?
Also, is there a helpful resource for figuring this out for other bit sizes? |
Tags |
1095, art, blade, brand, brass, carbon, cutting, drill, forge, harden, heat, knife, knives, man, material, materials, ore, plastic, press, sharp, sharpening, stainless, steel, tap, what kind |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
new to me Drill Press - Turret drill press | ATalley | Tool Time | 9 | 09-13-2014 09:35 AM |
Making a drill press out of hand drill | remist17 | The Newbies Arena | 5 | 12-03-2012 09:39 PM |
Old Drill Press | pjelect | Tool Time | 2 | 09-09-2005 11:30 AM |
Drill Press | Uncle Buck | The Newbies Arena | 0 | 07-01-2005 04:48 PM |
enough drill press? | seeker | The Newbies Arena | 3 | 12-26-2002 07:06 PM |