Making a framelock folder
A framelock folder CAD design is included in the cost of this course.
A framelock differs from a locking liner folder only in that no bolsters or scales are required and the liners are made of thicker material.
Minimum required equipment:
Drill press, belt grinder, band saw, a Dremel type cutoff disk arbor and discs, Torx screw#######, drills, reamers, a countersink bit, miscellaneous hand tools, sandpaper, a #2-56 SPIRAL POINT tap, T-handle tap wrench, tapping fluid.
Suggested equipment: Milling machine, buffing machine, sand and bead blaster, anodizer for titanium.
Materials required:
3/32" 6AL/4V titanium sheet, 1 1/4" wide blade steel, 3/16" and 1/8" straight pivot pins, a bronze bushing, bronze or Nylatron washers, and Torx screws.
Duration of course: 45 days.
Cost including CAD design: $59.95
Last edited by Don Robinson; 06-30-2006 at 07:49 AM.
|