View Single Post
  #11  
Old 01-19-2014, 05:34 AM
DanCom's Avatar
DanCom DanCom is offline
Skilled
 
Join Date: Sep 2013
Location: Leduc County, Alberta, Canada
Posts: 314
Jack,

Yes this is great advice. With regular brass stock a spin on the slack belt would be fine. Even better if you do this before you cut them to length.

In my case the wall of the mosaic pin was so thin I could risk disfiguring it and yes, they were already cut to about an inch long. It was much easier to enlarge the holes.

Dan
Reply With Quote