|
Adrew you have a point yes blades I have made from 440c can do any task a blade from s35vn can do BUT ill tell you right now if the s35vn is HT ed right the edge will deffinitly stay sharp longer than the 440c....But if your going to HT your own blades it is best to pick one and perfect the HT (wich takes some time a spec sheet is a good starting point but I always alter things when learning a new steel) But you should deffinitly perfect one before going to another. Wich is why I only use 440c and s35vn and still in experimental stages with 154cm...I can do 1084 but don't very often. But MRHC are you HT ing your own blades? or sending them out? that could change the whole situation
|