[matalpa]

Hi,

I have a whole knife-making set-up that I just don't have time for any more. It has been sitting in my shop for a while, so it is a little dusty, but the grinder might have all of 50 hours on it.

KMG grinder 2x72 with platen and 8" wheel. There is some surface rust- I wish I would have powder-coated it when I first got it. But mechanically it is perfect.

Dayton 1 1/2 hp motor currently set up for 110, but you can change a few wires and run it 220v
This motor is not variable speed, but there are 3 pulleys on the grinder and you can select the one that provides the speed you prefer.

Lots of belts for it. Maybe 40-50, maybe more?

4 bars of 52100 steel. Big enough for 3 hunting knife blanks.

2 pieces of ATS34- enough for 2-3 hunting knives

2 roughed-out knife blanks in ATS34

Lots of pins and rods for securing scales

5 sets of wood scales

Micarta for at least 10 knives

Liner material to go under scales- multiple sheets

Sorry there are no photos- Flickr and I did not get along tonight. Call me at 509-850-1839 and I can send you photos. No text messages, please.

Located in Spokane, WA. Sorry, but I am not willing to ship or break it up.

Thanks for looking.

$1400