Thread: New oven
View Single Post
  #1  
Old 03-04-2017, 11:19 AM
cnccutter's Avatar
cnccutter cnccutter is offline
Steel Addict
 
Join Date: Mar 2011
Location: Dorena, Oregon
Posts: 191
New oven

Had a good year last year so at Christmas I ordered a EvenHeat KO18 with Tap controls. Took a little while to get it made, shipped, and installed but it's now all ready to go in my shop.

Last night I got to run my first batch of 440c through and man it this oven a rocket! The Tap controls worked great and seemed to keep the temp even as it went up. I got the 220 version so didn't take long to fire. Total time was 1 hour 25 minute with the soak times included. Blades came out of heat treat at a good R62 with a plate quench. Don't miss the mess of the oil at all! Will temper them this morning down to a 60ish.
Can't say enough good things about my new oven.

Erik
Attached Images
File Type: jpg IMG_0762.JPG (143.6 KB, 13 views)
File Type: jpg IMG_0763.JPG (91.9 KB, 14 views)
File Type: jpg IMG_0761.JPG (63.4 KB, 11 views)
File Type: jpg IMG_0760.JPG (53.3 KB, 10 views)
File Type: jpg IMG_0759.JPG (86.9 KB, 12 views)
File Type: jpg IMG_0758.JPG (48.4 KB, 11 views)
Reply With Quote