View Single Post
  #1  
Old 10-21-2018, 07:20 PM
TWITHERS TWITHERS is offline
Enthusiast
 
Join Date: Aug 2011
Location: Linden, CA
Posts: 56
Rotary Table size?

May I get some input on a rotary table from you guys? I am going to buy one to try my hand at folders. I want to use it to make the circular slot for the stop pin. My mill is not mini but not full size either. It is a Grizzly 8x30. I assume I don't want the cheapest. Should I get a 6" or an 8". Is Vertex a decent brand? How about the Enco Phase II?
Reply With Quote