View Single Post
  #9  
Old 12-08-2018, 12:25 PM
squigly1965's Avatar
squigly1965 squigly1965 is offline
Steel Addict
 
Join Date: Jan 2010
Location: Modesto, CA
Posts: 257
So I looked for corbys. Problem is, I drilled hole at 5/16 for the bronze pin stock i was planning on using. And although they make 5/16 corbys. The 5/16 is the head size, with a thinner shaft to pass through the tang. Perhaps I can find a 5/16 brass or stainless cap screw and eyelet. Or is you guys have any ideas.
Thanks in advance

Chris
Reply With Quote