|
Wow! That's quite the machine, it will certainly get hot enough =350? is all you need. Get some good foam (maxform or something like that from knifekits.com) and you are in business. That's cool. My only concern would be That the workspace, or area where the foam goes is a bit small. Need a minimum of 12x12 inches, but more is better. Maybe you could fit a larger set of 'dies' (for lack of a better term) to increase that surface area.
Are you planning on making holsters, or just sheaths?
__________________
AT
"We shall walk with a walk that is measured and slow,
And watch where the chalk-white arrows go
To the place where the sidewalk ends." Shel Silverstein
Last edited by ATalley; 11-06-2015 at 07:52 PM.
Reason: Misspelling
|