I am new to this forum and knifemaking. However, I am well educated in casting. I am a goldsmith. Too bad I did not see this sooner. If you want any gold or silver, either fine or sterling cast, I can do it and do it with quality. I can also make ingots, bars and wire to just about anysize. Or I can even roll metals into sheet, just not wider than 1 1/2" If you want to make a model from wax and have it cast, I can do that too, the wax can be purchased from
www.riogrande.com
Best of all, my custom casting is something I am willing to trade for.