Boyar Schultz 612 surface grinder
Hello!
I've been blessed with an older model Boyar Schultze 612 surface grinder, and am in the process if getting it up and running. It's missing the wheel nut to afix/secure the grinding wheel ! It is1 1/4" in diameter, havnt figured out the pitch yet and I can't tell if the threads are right or left handed. I know its supposed to be a spanner or pin wretch type nut to tighten and loosen.
Does anyone know where I could get a replacement? I may have to get one made. Havnt had much luck causally searching the interwebs. However, I did locate an old manual from antiquemachinery.com, but it doesn't say much about it (no part number or anything) it does mention a special puller that originally came with the machine, but I don't have it either.
Any help would be appreciated!
I'll try and add photos later
__________________
AT
"We shall walk with a walk that is measured and slow,
And watch where the chalk-white arrows go
To the place where the sidewalk ends." Shel Silverstein
|