View Single Post
  #3  
Old 08-05-2016, 01:07 PM
shiny shiny is offline
Enthusiast
 
Join Date: Jul 2016
Posts: 38
Nice to hear that the small forge I am planning to build is sufficient in size. So a small forge goes a long way heat treating a knife. Thanks Doug. I will make that pass through port for sure!

I might give the perlite-aluminium oxide lining a go
Has anyone tried it? I can get the ingredients dirt cheap. I think I am going to try it. Or maybe plaster with sand? I do even have the ingredients at home.
Reply With Quote