Thread: 416 Bolsters
View Single Post
  #4  
Old 02-11-2019, 09:58 PM
Steve's Avatar
Steve Steve is offline
Moderator
 
Join Date: Jun 2002
Location: Manti, Utah USA
Posts: 1,239
I rough them (Polish the choil ahead and slightly under the front of the bolster) so that they don't slide around when pinning, though they are clamped in place, also. No epoxy, or solder. If you solder bolsters, you'll get flux trapped under them and it will seep out and corrode the tang, choil, in time. Wow this is long overdue, I apologize!


__________________

http://www.srjknives.com
NRA Endowment Member
Knifemakers' Guild Member since 1971
"May you live all the days of your life." - Jonathan Swift
Reply With Quote