|
When you say that your forge won't handle a bigger knife than that do you mean that it won't heat it for hardening? A solution for that would be to have a port on the back side of the forge that you can stick the far end of the blade out of. You just work the blade back and forth to heat it evenly. With practice you could probably heat a blade twice the length than the depth of your forge.
As far as forging goes I have a forge that is 7" deep and I could theoretically forge a 36" sword blade in it because all you can really work with your hammer is about 3-4" at a time.
To be honest, I'm really prejudice against forge finishes and think that few can bring them off well, though I have to admit that you did pretty good. I would also suggest that you clean up the spine a little better to get rid of the nicks and hollows
All in all you are definitely showing improvement.
Doug
__________________
If you're not making mistakes then you're not trying hard enough
|