View Single Post
  #3  
Old 10-10-2007, 07:38 PM
tbark44 tbark44 is offline
Member
 
Join Date: May 2006
Posts: 22
Hello Mack , Here is what I use for them , I use .030 titanium , I cut the width and Bend the Kink in the spring over a solid surface with a nail laying on it , put your spring on the nail where you want it bent cut it long enough so that if it breaks because you over bent it you can move up and try it again , I dont use heat but when the spring is set lay a thick pair of pliers on it with the jaws open and hit them with a small hammer , dont try and bend it back because it will break , take needle nose pliers just in the front of the Kink hold it solid and wiht another pair of pliers bend it opposite Move forward and bend your curve slowly when you get it bent like you want it cut it to length and install it it will work great , T
Reply With Quote