ran into problem doing handle
So i ran in a problem i was grinding a handle after epoxy and got it all done before noticing there is a small gap between tang and material on the front of the spine idk maybe not enough epoxy or wiped to much off either way its there so i am trying to figure out how to fill it . its small so i cant fit a "oral syringe" in there that i use to measure the epoxy i tried a insulin syringe with a metal tip but the epoxy is to thick to squeeze out the tip the gap is so small i think if i just poured the epoxy on and hoped for the best i think it would be to thick to seep down into the gap.....its small but noticeable has this happened to any one any ideas how to fix it?
|