View Single Post
Old 07-31-2017, 05:41 AM
Crex's Avatar
Crex Crex is offline
Join Date: Sep 2002
Location: Acworth, GA and/or Hanging Dog, NC
Posts: 3,494
Dremel with a cut-off disc with light feathering cuts if the above suggestions are too difficult/hard. Just don't try to pressure hog the cut. Jim's right on keeping her cool, you can actually cut it with the Dremel lying flat on a wet rag. Like Ray's idea of sharpening the leading angle when you are through truing it it a "Tactical Cai".

Carl Rechsteiner, Bladesmith
Georgia Custom Knifemakers Guild, Charter Member
Knifemakers Guild, voting member
Registered Master Artist - GA Council for the Arts
C Rex Custom Knives

Blade Show Table 5-J
Reply With Quote