View Single Post
  #1  
Old 09-16-2017, 04:32 PM
Rasmus Kristens Rasmus Kristens is offline
Steel Addict
 
Join Date: Jul 2014
Location: Denmark
Posts: 185
brass pin for friction folder pivot. How to attach?

Hello again

I see a lot of people use screws for their folder pivots, but i dont have any right now and would like the clean look of a pin as my pivot.

But now i'm realising i have no clue how to attach the pivit pin?
If i use epoxy, i'm afraide it will glue the blade in place also. I hear about peening, but i only have regular hammmers and nothing like an anvil, and im not even sure you can peen a pivot pin?

Do you have any sugestions how i go about this?


Thanks

Rasmus
Reply With Quote