View Single Post
  #4  
Old 02-11-2018, 12:52 AM
MJP MJP is offline
 
Join Date: Jan 2018
Location: Montreal QC
Posts: 9
Erik and Don, thanks for your replies.
I was pretty much wondering about the flux possibly causing some corrosion under the solder where it cannot be seen and then eventually causing corrosion? I would also trust the integrity of the join if it is correctly done. Would you mind telling me which solder and flux you use?
I would think that the corrosion under the flux thing of course cannot happen with spot welding but like you say Don, there are cons with that method too.
Maybe I just over think things sometimes but I am so scared of making a bad choice and then messing things up.

Thanks again for your replies.

Mike
Reply With Quote