View Single Post
  #10  
Old 09-26-2017, 01:33 AM
Rasmus Kristens Rasmus Kristens is offline
Steel Addict
 
Join Date: Jul 2014
Location: Denmark
Posts: 185
Quote:
Originally Posted by dtec1 View Post
Yeh deffinitly peen the scales separately...I have never done any folder with pins like that although I have only done liner locks not friction folder but in either case I would think there is much less chance to mess something up and probilly eaiser to just drill and tap holes in the brass and screw down the scales with small screws like 2x56 that's just the way I would do it probilly not the best way
I think I will stick with the pins, i like the look of them better than screws :-)

I already shaped the scales, so I can't find a place for extra pins that I like on this build. I will try a lockback after this build, I will peen the liners and scales seperetly on that knife.

It's learning the hard way, and I really appreciate your guidance :-)

Thanks
Reply With Quote